Fireplace technical info - A focus on service for your peace of mind

Fireplaces; Stone fireplace mantels from Capital Fireplaces

The following fireplace technical information has been compiled to help you make your choice of fireplace an easy one.

This is likely to be one of the more expensive additions you make to your home and we hope that with the following information it will be an alteration you will be pleased with for years to come.

Reassurance before you choose your capital collection fireplace.

All cast iron products are manufactured in iso 9002 accredited manufacturing facilities.

All the gas fires we supply are tested in accordance with ce requirements and are ce marked.

Due to the manufacturing processes all measurements are approximate and may vary slightly so allow for a tolerance of ±10mm.

The colours shown in the brochures are as accurate as possible, but if the colour you require is critical then please consult your retailer before basing all your decisions on the colours shown here.

Gas fires with a gas input of 6.9kw or less do not normally require air vents. there are some circumstance where vents may be required. this is determined by your installer carrying out a spillage test during the commissioning process. if your chosen fire has a gas input greater than 6.9kw, a vent from outside will be required. please ask your retailer for further information.

There are occasions when designs, or products are altered or discontinued without prior notice (a reserved right), so if you are about to set your heart on a particular fireplace, please consult your retailer before making that final commitment.

Focus on fireplace quality & after care

Reassurance before you commit to the installation of your capital collection fireplace.

All installations must be carried out in accordance with the requirements set out in the building regulation documents, in particular, approved document j. there are independent bodies which have been approved to carry out installations in accordance with these regulations. for gas installations the most recognised independent body is corgi. please confirm with your retailer that your new fireplace will be installed appropriately. if you have your new fireplace fitted by a corgi registered fitter you will be given a certificate stating that your installation has been carried out in accordance with the building regulations. if you do not have one of these certificates then you will have to arrange for your local building control officer to inspect your installation and approve it.

Fireplaces; Stone fireplace siuites from Capital Fireplaces

Your capital collection fireplace is made up of a number of different components and it is important to ensure that your installer not only meets the requirements above, but that he also has the necessary experience to fit all the required components, for example an agean limestone suite.

Variations in colour, veining and fossil formation in natural products are not considered defects, however in the unlikely event that there is a defect in any of the products shown in this brochure, then a replacement will be supplied without hesitation. of course, this requires the products to be fully inspected prior to installation as no responsibility for re-fitting or redecoration can be accepted if defective products have been installed. in this case and in the case of accidental damage after installation, in-situ repairs can be made by specialists, subject to prior agreement of terms with your retailer.

Understanding your new capital collection fireplace, its aftercare and maintenance.

Gas fires

A gas fire is a technical piece of equipment and, just like a gas boiler needs regular servicing. please ensure that you have your gas fire serviced regularly by a corgi registered installer. this will help you enjoy safe and trouble free enjoyment of your fireplace for years to come.

Fire bowl and firebasket aftercare

For the chrome and bronze finishes please do not use an abrasive polish as this will remove the plating. simply use a lint free cloth with a non-abrasive, water-free polish for these products. the solid brass products may be polished using proprietary products.

All images on this website are the property of capital fireplaces ltd and are subject to the laws of copyright.